What is the process for removing a one way metal bolt?

Answer by  eyeguy (3760)

To remove the bolt purchase a Tapkit. Drill a hole into the center of the bolt approximately one half the diameter of the bolt, then insert a Tap bit a tad larger than the hole ,screw the tap bit snuggly into the bolt, place drill inreverse, unscrew bolt.

Answer by  neeravvyas (84)

i worder there might be special tool, still try to use a pair of needle nose vice grips to grab the head and slowly unscrew the bolt. also try to grind the head off with a hand held angle grinder.

Answer by  hibpmgirl (2166)

If its one way in and no way out the only way to remove it is by cutting it. You will have to do this carefully so you dont damage what it is attached to but it must be cut.