What is the right process for removing a rear interior door panel in a Dodge Stratus?

Answer by  tkarlav (1502)

first remove all the trim screws , then carefully pry out on the panel without scrathing the door jam or panel. then lift up slightly and disangage the handel cable , the remove the weather shield from the door to access the iners

Answer by  Teaberry (846)

Unscrew door handle with the screws in the center of the dooe rest. Remove door plugs and screws from behind the door and at the bottem of the door. Pry the panel away from metal door uting a door puller tool and unsnap connections. Release door lever rod. Disconnect wiring harness.

Answer by  dee73 (1062)

Remove the trim screws,pry the cover back, do not scratch the door jam or panel. disengage the handle cable,remove the weather shield and access the liners.

Answer by  heatherbooboo (655)

You can start by removing the cover, it is held down by two or three plastic clips. Do not pull to hard or you will break them.

Answer by  cgrid76hotmailcom (545)

open the door first .remove the window crank if it has one .make sure that when you pop the cover off you dont get any grease on your interior Now.

Answer by  Gaur (7676)

If the lock sticks out of the top of the inner panel, remove it--usually by unscrewing it. Locate the inside door lever that opens the door. Pull on it so that you can see if there is a screw underneath the lever.

Answer by  neielg (311)

The door panel is tricky to remove, it be done by removing the screw in the top right area of the door panel. Then the screw behind the speaker grate panel. Lastly, the screw in handle located below the door locks and switches.