How do you replace the front wheel bearing in a Toyota Sienna?

Answer by  Amber40 (24961)

The process may vary a little bit. In most cases the wheel is remove. The rotor will usually need to come off. Then the spindle nut is removed after the cotter pin is taken out. Then the old bearing is pulled and the old grease is removed. The new bearing is then installed ant the process is reversed.

Answer by  mikkie180 (167)

This will require getting the steering knuckle off the vehicle, then the old wheel bearing will have to be pressed out the new one preesed in.

Answer by  carfixer (243)

You'll need to safely raise the front of the vehicle and make sure the parking brake is on. Then take off the wheel and brakes. You'll probably need a special tool to remove the bearing but a local auto parts store should be able to help.

Answer by  cuckoosygmailcom (86)

Usually you have to pull the brake assy off then the brake disk and the small cap in the center of the axle. There will be a large nut under it that needs to be removed. This will give you access to the wheel bearings in front.