How do I remove the front wheel bearings on a Durango?

Answer by  iantm (127)

Start by removing the wheel, the brakes, and the drive axle retaining nut. Undo the ball joint on the upper control arm. Remove the three bolts holding the hub to the spindle. Hammer the hub bearing assembly off of the spindle (this will take considerable effort). Clean the surface of the spindle to ensure no issues and reassemble.

Answer by  kennethjgoodson (4903)

The best thing to do when you are doing wheel bearings on a Durango is to pull the wheel off. You will then take the caliper, brakes, and rotors off. Once you have the rotors off you can then pop the dust cover off and the bearings are behind the nut right there.

Answer by  codykeller (153)

Remove lug nuts, wheel and tire, front brake caliper, castle nut and cotter pin to pull cap off and expose hub bearing. Remove old/damage bearing, replace with new