How do you bleed a v6 fuel system?

Answer by  nate (199)

you shouldnt really have to bleed it at all. all you should have to do is prime it a couple of times by switching the key on and off but when you switch it off wait about 10 seconds so it will prime again when you switch it back on.

Answer by  cajuncuz (177)

First wear gloves to protect your hands. Open the hood and look for the schrader valve.Put a rag over it than loosen it. Let air out. Then re tighten.

Answer by  chase (6)

Find your fuel rail and at the end there is a valve. Put a flathead screwdriver in the valve and air and gas should come out. Continue until it's just gas.