How do I replace a water pump in my Chrysler Town and Country car?

Answer by  nicksdakota (74)

Remove serpentine belt and heater hoses. Remove all bolts holding pump in place. Pump can then be removed. Clean area, and install new pump using a new gasket.

Answer by  kennethjgoodson (4903)

You are going to need to pull the alternator off and then you can see the waterpump. You should replace the belt also when you do the pump.

Answer by  doc325 (454)

The water pump is on the drive belt side. Drain the coolant, remove the belt, remove the water pump bolts and remove pump. Reverse to install.

Answer by  hwht25 (441)

Well it's similar to replacing the water pump in any car. Locate the water pump in the hood. Then replace the part that you have purchased with it and have it close to the hood.