How do I replace a Chevrolet C2500 brake light switch?

Answer by  Jenny30 (161)

Locate break switch under break peddle. Disconnect wiring. Remove switch and replace with new switch. Reconnect wiring. Reinstall switch and test to verify fix.

Answer by  JohnHolmes (2660)

You can replace the switch by removing the old one from the rear of the break pedal. It comes out easily all you will need is a screwdriver and something to hold the pedal up. Replace new one and attach the same wire that were on the old one.

Answer by  ajith66 (10)

Locate break switch under break peddle. Disconnect wiring. Remove switch and replace with new switch. Reconnect wiring. Reinstall switch and test to verify fix.

Answer by  ranakhan (164)

break switch are located under break peddle.Disconnect wiring then remove switch and replace with new switch then reconnect wiring and reinstall switch do hope it would work now.

Answer by  chrijohn (75)

Take old brake switch out behind brake peddle by detaching wiring. Bolt new brake switch in and re connect wires. Be sure to tighten screws after completion.

Answer by  georgekutty (173)

To loose the nuts of old brake light switch,then remove wires also. Put new shitch and fix the wires properly then tight with screws.

Answer by  thattractorguy (2970)

The switch is above the brake pedal. Just unplug the old switch and unbolt it to remove it. Plug the new switch in and bolt it on.

Answer by  japratt (1687)

If you are wanting to replace this brake light switch you will first have to take off your dash board.