How do I remove the door panel on a Dodge Caravan?

Answer by  thelostone (1457)

There are screws on the handle. Remove them then the panel is held on with snaps. Start at the bottom and pull, lift up when you get to the window.

Answer by  Jag636 (94)

First check for screws holding the panel on. Usually 1-3 screws secure the door, and also the switch panel. These screws are covered by small trim pieces that pop off. Furr tree clips also secure the panel. a furr tree removal tool is available, but a ftat blade screw driver will work. pry loose and lift up.

Answer by  subramani (29)

Remove the plug and remove screw attaching door pull cup to inner door panel. Remove switch bezel and disconnect power window switch. Remove screws attaching trim panel to door from below map pocket. equipped, remove window crank. screw holding door trim to door panel from behind inside latch release handle

Answer by  Atomicrayon (2504)

You'll need to open the inside of the door, you'll notice some rubber guards that can be removed with your fingers, from there you'll need a screwdriver.

Answer by  soccer593 (476)

Open the door and roll the window all the way down. Remove crank handle and courtesy light. Remove screws and door panels.

Answer by  neielg (311)

Take out the plug and eliminate screw join door pull cup to interior door pane. get rid of switch bezel and separate power window/memory switch. eliminate screws attaching trim panel to door from below map compartment. If equipped, eliminate window crank Get rid of screw holding door trim to door panel from behind inside bolt release handle.