What is the process for rear wheel removal for a Dodge Caravan?

Answer by  Wrenchman (638)

Begin lifting the wheel with a jack. While it's touching the ground, loosen the lug nuts. Lift the car, use a jack stand, remove the nuts, pull off the wheel.

Answer by  78Camaro (200)

Break the lug nuts(under the hub cap) loose with a lug wrench, then jack the rear of the vehicle up and remove the nuts the rest of the way.

Answer by  rookie105 (823)

You need to remove the wheel cover, if you have one, use the proper size socket to loosen the lug nuts and remove the tire.

Answer by  neielg (311)

First, place the car ,block the engine so that the rear wheel clears the ground. Then, apply handbrake and find the locking wheel nut. Next, remove toolkit from boot, crank the wheel nuts on said wheel (do not remove). Finally,affix jack, pump the jack till the said wheel has airtime and remove the loosened wheel nuts.

Answer by  champaign9497 (11977)

Just jack the vehicle up take the lug nuts off and pull the wheel off that is all there is too it.

Answer by  Kozmo (286)

Loosen the lug bolts slightly, place jack in safe spot under car, jack vehicle up, undo all tire bolts, remove tire from vehicle. Tire wrench is in compartment in driver side rear luggage compartment. Spare tire is located under vehicle just behind rear bumper and is lowered on cable by cranking on a bolt located under carpet in luggage compartment.

Answer by  alexandru (19)

the process is very simple! take the cover over the wheel and unscrew the bolts with a special key,then you can take the wheel and use it!

Answer by  Gaur (7676)

Push up on metal retaining clip (Sensor Connector At Hub And Bearing) until it bottoms. This will release wheel speed sensor head from hub and bearing.