How do I remove door panels on a 1996 Jeep Grand Cherokee Laredo?

Answer by  Advizor (230)

There are 4 screws covered by small little circle style covers. Remove the Circle covers and screws and start at the bottom of the panel and pull carefully.

Answer by  NateB (571)

Door panels are held on by a system of screws and tabs. The screws are usually along the bottom and along the side by the door hinge and sometimes covered with little tabs that pry off. After removing the screws, pull out on the door panel until all the tabs are freed. Then push upwards to slide off the panel.

Answer by  SpoonNZ (56)

There may be some screws (check inside the door handles etc), but most of it will be held on with plastic clips. Get some leverage under an edge and gently ease it off. Easy!

Answer by  Allstar (2071)

Look underneith all the surfaces, there should be holes with screws in them. Remove the screws, and then the door panel should pry right off. Be careful with the wires.

Answer by  James916 (539)

There should be a few bolts holding on the door handle. Then there will be clips all the way around the panel you can pop off with a screwdriver.

Answer by  Amber40 (24961)

Start my removing anything that screws or bolts to the door. Then go around the edge of the door panel with a trim tool to pop the clips out.

Answer by  JRossi17 (788)

Find all the noticeable screws and pop tabs, after removing these use a door tab puller (get at autozone) and pop the tabs out. This will reveal the locks.

Answer by  beck (1099)

Typically any door panel is held on by screws and clips. The screws are almost always located along the bottom and sides of the panel. They are sometimes covered with little caps that pop off. Once you've removed all the screws pull the bottom out and then lift upwards.

Answer by  yaomingjr32 (120)

just go to a car mechanic and they will help you remove it or information about it to remove that.