How do I install an oxygen sensor bank 1 on a Chrysler Town and County?

Answer by  mb (5482)

You really need a computer to figure out which of the senors is malfunctioning. There are 8 to 12 sensors that it could be based on the car model and year. Once you find the culprit it popps right out and the new one goes right in.

Answer by  Amber40 (24961)

Well the first step is to figure out witch side of the engine is bank one. Then you will need to remove the oxygen sensor on that side. You will need a special oxygen sensor removal tool that you probable find wherever you get the sensor. Remove the connector then the sensor and install the new one.

Answer by  vhoyet (8)

Well the first step is to figure out witch side of the engine is bank one. Then you will need to remove the oxygen sensor on that side. You will need a special oxygen sensor removal tool that you probable find wherever you get the sensor. Remove the connector then the sensor and install the new one.

Answer by  Amber40 (24961)

Start by finding out which side is bank one. Then unhook and remove that sensor with a o2 sensor socket. Then install the new one with some o2 friendly anti-seize.

Answer by  worker4275 (175)

First, place your hands on the radiator valave of the carbon intake system. then, remove the pressure cap and set aside.

Answer by  japratt (1687)

If you are wanting to install this type of sensor on your Chrysler you will need to be able to get under the car so as to take out the other sensor first.