What are the most common fixes for an a604 transmission?

Answer by  widgit (65)

The most common fix for the A604 transmission is to clean the contacts on the solenoid connector. Use a wire brush to clean off the oxidation.

Answer by  Wiki10 (70)

Usually the problem is caused by dirt on the contacts of solenoid. Fix is very simple. Just take a brush and clean the surfaces. It will solve your problem. Use a hard or may be wire brush to clean the oxidation and rust. Maintenance fluid and replacing filter in time will help protect from this problem.

Answer by  Christian9247 (5042)

You need to clean the wiring of the A604 transmission. Clean the contacts on the solenoid. A wire brush or some brillo woks wonders!

Answer by  JohnAndrew (199)

The easiest and most common way to clean an A604 transmission is to clean the contacts found on the solenoid connector. Use a brush/wire brush to clean off any oxidation.

Answer by  StevenB (128)

The most common problem is dirty contacts on the solenoid. You can take a wire brush and clean the contacts. If this is not done the transmission can go into limp mode.

Answer by  Kozmo (286)

If you have one of those wretched trouble-prone A604 transmissions, and you start having transmission trouble, you can put it in its limp mode yourself.

Answer by  cuckoosygmailcom (86)

If you suspect that Dexron has been put into your A604/41TE, invest the $40 or so to have it replaced immediately Dextron is a "grabbier" fluid - the A604/41TE is designed to slip a bit during shifts - and ultimately it'll cause the transaxle to fail.. You can have the retaining pin welded into the carrier

Answer by  jamminjan0208 (102)

Maintenance fluid and filter replacement every 80,000 miles, using Mopar 7176 is necessary for keeping the transmission in service. If this doesn't correct the problem then a rebuild may be the only solution.