My electric door locks are not working on my Ford F-350, what should I do?

Answer by  happytimes63 (865)

Sometimes the only problem is a bad fuse. Check the fuses to see if you have a bad fuse. Otherwise you probably have an electric circuit that is not working that will require a mechanic.

Answer by  bug57 (1048)

Diagnosis of locks is not difficult, if you follow some simple steps. Check the window switch and make sure the connector is inserted correctly. Try changing for a known good switch and see if that corrects the problem. Test the motor- operate switch and see if you're getting power (12 volts) to the motor connector. If not, it's the switch.

Answer by  bazeethvm (8)

Sometimes the only problem is a bad fuse. Check the fuses to see if you have a bad fuse. Otherwise you probably have an electric circuit that is not working that will require a mechanic. Check for power to the switch u might wanna get a ohm meter and a test light

Answer by  user21 (361)

Try checking your fuse; it may be blown. If it is, you can simply go to any auto store and buy a replacement for a few bucks. It's something you can install yourself.

Answer by  Anonymous

Check for power to the switch then if there isn't power there u know its between the switch and fuse block if there is its probably the switch or power to the actuaters good luck u might wanna get a ohm meter and a test light

Answer by  TimmyTimmy (23)

First check the fuse. If it's broken, replace it. If the fuse if fine, then your the problem is your switch. Then you have to get a professional to take a look at it.

Answer by  Jay18 (112)

Occasionally door locks on vehicles fail and need to be replaced. This usually isn't a do it yourself kind of task so it would be best for a professional to look at it. If under warranty, it can be fixed for free. If not, it can usually cost about 200-500 dollars depending on the vehicle.

Answer by  Amber40 (24961)

Well if none of them work then it should either be a fuse or the switch. Check both to see which is the problem.

Answer by  rookie105 (823)

to start did you check the fuses? if they are all good next I would look at the driver side switch assembly and make sure they are plugged in corectly