How do you wire an above the gournd swimming pool?

Answer by  eatwrite (1559)

Breaker boxes or transformer for outside equipment is needed. The above ground swimming pool can be pulled into an existing pole that have a green ground wire with 230 voltage. The three wires in the motor need to have an elbow attached. Then run the wires through the conduit.Check with an electrician.

Answer by  JohnHolmes (2660)

You will need to wire it to the house or garage electric underground. Dig a small trench around 2 inches deep for the conduit and then run the new wiring to your current breaker box.

Answer by  Sara89 (367)

The pump should be wired directly; avoiding short distances of less than ten feet between the power source and the outlet. Local codes may vary.

Answer by  ttownbeast (341)

All built in pool lighting must be hermetically sealed, all connections must be water tight for everything from pumps to the motorized pool cover and well grounded to minimize shocks.

Answer by  Jalaine11 (2043)

The answer to that question depends on what exactly you are wanting to wire. The heater, the filter system etc? Try checking you user manual or online for specific help.