How do I remove a power steering pump from my Pontiac Sunfire?

Answer by  VSauce (85)

The power steering pump is located below the alternator. Therefore you would have to remove the belt, followed by removing the alternator, then remove the power steering pump reservoir. Once all of these things are out of the way, you should be able to access the power steering pump. It should be held in by three or 4 bolts.

Answer by  Anshul25 (34)

Disconnect the negative battery cable, remove the drive belt, disconnect the inlet-outlet hoses from power steering pump, unbolt the power steering pump from the bracket and remove it.

Answer by  Amber40 (24961)

Typically all you need to do is remove the belt then the pump by removing the bolts and lines. To get the belt off first though you will move the tension enough to get the belt off.

Answer by  Jennytaurus (144)

Locate the power steering pump. Remove the hoses and drain reservoir. Remove serpentine belt. Remove any bolts that hold the pump in place. Remove pump and reinstall pump in reverse order.

Answer by  bhuvana (4)

This is located below the alternator. you would have to remove the belt, followed by removing the alternator, remove the power steering pump reservoir. Once all of these things are out of the way, you should be able to access.

Answer by  sangeetham (7)

loosen the clamps on the end of the each power steering pump hose with a screw driver. pull the pump's hoses off of the pump.