Question by  rajneesh (18)

Is it difficult to wire a 2 way switch?


Answer by  john11 (617)

You are talking about a single throw double pole switch. connect one end to the wire and the other two poles to independent wires.


Answer by  kennethjgoodson (4903)

It is not difficult because you will just have one hot wire and one ground wire. Just make sure you have them hooked up correctly.


Answer by  pmm62 (243)

No. A two-way switch is the simplest of all. The switch is connected in series with the load device (such as a light.)


Answer by  EL (23)

Wiring a 2 way switch is not difficult. One needs only to follow the diagram carefully and pay close attention to the colors of the wires.


Answer by  John (9008)

It is not hard, but all electrical work must be done very carefully. When you work with electricity, fire and shock are always serious risks.


Answer by  Sparky101 (366)

Without knowing the exact type of switch, circuit wiring and intended application any switch can be difficult to wire. If unsure it is better left to an electrician.


Answer by  tavidoru (25)

No its not difficult at all.You need to take out the power supply to the house so that you will not get electrocuted and always know that safety comes first.The first time I had to wire a switch I was 16 years old and did it in 2-3 minute so its not difficult.


Answer by  Liz59 (10966)

Yes it is pretty hard to wire a 2 way switch. You need to make sure that both wires can connect to the center of the switch. Be careful. It is dangerous.


Answer by  shareefponnichigmailcom (41)

no difficulty to wire a 2 way switch but it should be take care because there is a chance of short circuit.


Answer by  me40 (43)

Nope. Bulb goes to center post on each switch, hot to one one post on each switch, neutral to the other posts.


Answer by  Liz59 (10966)

Well, a two way switch works in pairs and yes it is difficult to wire because you will need to connect both wires in a way that they will work together.

You have 50 words left!