How do you remove the back panel of a Whirlpool Ultimate Care 2?

Answer by  Tinu (33)

Remove two trim caps on either side of the control panel. Remove two screws that secure the panel to the cabinet. Now pull the panel up and out. Disconnect the wire harness from the lid switch connector. Remove the two gold clips to the rear panel of washer. Tip the cabinet towards yourself and pull it off of the frame.

Answer by  megha76 (55)

Remove two trim caps on either side of the control panel and the two screws that secure the panel to the cabinet. Then pull the panel out.

Answer by  Ben3889 (178)

All you have to do is pull out the machine and remove all the screws then the back panel will come right off.

Answer by  knowitall90 (40)

You will need to remove the two screws on the back right and left corner in the back. Pull the panel slightly forward and it should come free.

Answer by  japratt (1687)

You will have to have your basic screwdriver to do this task. You will need to remove each screw to be able to remove the back panel.

Answer by  rema (36)

The screw around the backpanel turn to left and remove that all screws,then that panel just pull in front then up. Now there is removed. (If any wire inthe panel pull that wire slowly remove. )

Answer by  2525252 (717)

Well you just open according to the screws but I recommend not opening it. When you open the panel make sure to screw it back on though.