How do I take apart the door panel on a Chevrolet pickup?

Answer by  thelostone (1457)

There are several screws that you need to remove that are part of the handle you use to close the door. After you remove those the door is help on by snaps that can be popped off starting from the bottom of the door. Then lift the panel off.

Answer by  looneylopez (22)

First you take out the clip that is behind the manual window crank if it has power windows, no need to worry. Then you have to take out all th visible screws. Then pry panel off being carefull not to break inner retaining clips, ta dah your done!!

Answer by  dumbduck (29)

Roll down the window. Remove the window handle. Remove the cover around the handle/lock area. Remove two Phillips head screws from the door pull handle. Remove the plastic panel that covers the mirror bolts. Pry away the plastic door panel from metal door shell. Lift the door panel upward to unhook it from the window lip. Done.

Answer by  Ralphie1954 (420)

First lower the window all the way to the bottom,then carefully remove the window crank handle or power window button. Remove any door handle or lock hardware and armrest. With special forked tool, pop the plastic clips starting at the bottom of the door moving upward equally on both sides. Then lift up and off.

Answer by  SheltonLaird (23)

Roll the window down. Then you will remove the door handle. Remove the two Phillip head screws. Pry the plastic panel. Then lift door panel upward to unhook.

Answer by  garymarkle (599)

start by removing several screws that are part of your door handle assembly, the rest of the door is held on by snaps.

Answer by  okaylumberjack (83)

Door panels are usually installed with simple plastic screws/mounts, which can be easily pried by carefully using a screwdriver or other prying implement.

Answer by  eholts56 (33)

There are usually small phillips head screws all around the door panel that you have to remove. Then the door panel can be removed by prying it away from the door.

Answer by  Bart41 (178)

First remove the window and door handles which are usually attached with ring washers. After this simply remave all of the screws that are holding the panel in place. The door panel should simply now just pull off. If you have power windows and doors you will have to unplug the wiring harness.

Answer by  soccer593 (476)

Roll down the window and remove the window handle. Take out all of the screws holding the door in place. Pry the panel and lift it upward to take it off.

Answer by  Amber40 (24961)

Start by unbolting or unscrewing any thing attached to the door. Then you a trim tool to pop the clips out along the edge of the panel.