How can I perform PT Cruiser blinker switch repairs?

Answer by  TravisUSMC (979)

The blinker relay for this vehicle is round and aluminum in color. It is located in the fuse panel on the lower left side of the panel. Locate the fuse panel and you will see it. It is fairly large and takes up a lot of space on the panel. Grasp it with your fingers and gently pry it out.

Answer by  mannersandsuch (1796)

I would caution you greatly at trying to perform this repair your self, as new car everything is hooked up to computer that needs special equipment to service.

Answer by  laura27 (1216)

Disconnect negative battery plug and power steering switch. The look of the relay is round and has aliminum color. Location is on lower left side in fuse panel. Very large and takes up a whole lot of room. Gently grab with finger to pry out. If need help consult mechanic.

Answer by  Xceptional (642)

There are a couple ways to diagnose a bad blinker, in general you either have a broken blinker bulb, or a bad fuse. This is a fairly broad question because there are many different models of your type of car. I would either consult a mechanic personally, or refer to your user manual.

Answer by  laura27 (1216)

Find the blinker relay that has aliminum color that is round. Therefore,fuse panel is located on lower left side of panel.Grab it and take out gently.Disconnect negative battery terminal and raise vehicle. disconnect from power steering switch. Make sure you use deep socket/extension to remove psps. Seal threads with new switch with teflon tape. Install reverse of removal,tighten the switch.