I need to know how I can hook up two sound systems to one receiver?

Answer by  bmh0012 (21)

You will need to purchase a "Y-Cable" to feed each system. However, you must make sure that you do not overload the system and blow out your speakers. You might also look into transducers.

Answer by  Liz59 (10966)

Well to hook up two sound systems to one receiver, you need to buy a connector cable. The connector cable must connect the two sound systems together. Then use another manual cable and connect from the system connector cable to the receiver cable. This should allow both to work fine.

Answer by  Hank81527 (76)

Use a "Y" cable from the left anf right channel line outputs of the receiver and connect the left and right connections of the "Y" cable to the inputs of the audio amplifiers. An RCA connector is the most common type. If not adapters may have to be used for the interface connections

Answer by  mturk9856 (26)

You will have to get a splitter for your sound cable, which will be available at any Radioshack or electronics store.

Answer by  Liz59 (10966)

You need extra outlets and or connector cables to hook up to the receiver. You can purchase these on ebay.

Answer by  DeeBo (29)

This depends entirely on the connections available on the receiver. Are there HDMI, optical, coaxial or regular composite cables. If HDMI is available that would be your best route.