How should I do a lug stud installation for a Toyota?

Answer by  ExiledConnections (57)

Place vehicle on jacks remove the wheel from the hub check all other studs for damage. remove the brake caliper a Install New lug studs, re-assembly is reverse of removal

Answer by  chris70 (301)

Their really isnt any thinh different about the lug studs for a Toyota then other cars except that you need the proper Toyota tool. This tool is located in the trunk and fits securely over the lug. Its more of a anti theft device that makes it difficult for some one to steal your wheels.

Answer by  MC23 (85)

Place the vehicle on jackstands, Then remove the wheel from the hub assembly and check all other studs for thread damage. finally remove the brake caliper and any other components that will prevent removal of the brake rotor. Install New lug studs, and re-assembly is reverse of removal.

Answer by  Amber40 (24961)

First the lug nut must be removed. It should come out through the back of the rotor. You can use a special tool to press it out or use an old lug nut and hammer it out the back. The new one can the be installed using spacers and a lug nut to draw it into place.

Answer by  Diisruptor (249)

You must remove the hub/axle out of the vehicle and bang the bad stud out with a hammer, replace with the new stud only if you have impact tools.

Answer by  Steven (309)

After removing the wheel, you need to disassemble the rotor so you are able to swap out the studs with new ones.

Answer by  laura27 (1216)

Put vehicle on jackstand. Take wheel off the hub assembly. Check other studs for damage of thread. Take brake caliper and all components thats in the way of the brake rotor off. Finally put new lug stud. Reassemble to reverse to remove.

Answer by  Amber40 (24961)

The first thing to do is to remove your wheel. Then remove your brake caliper and secure it out of the way. Next remove the rotor from the spindle. The using a press or old lug nut and a hammer drive the wheel stud out. The install the new lug buy pressing it in or by using a lug nut.

Answer by  rookie105 (823)

remove wheel and then remove rotor, hit out the old stud from the front side then replace with new stud, using a steel bar bang new stud in place or use wheel lug and washers to pull lug through

Answer by  japratt (1687)

If you are wanting to install this type of lug stud you will need to get under the car. You can input the lug where it should be eventually placed.