How do you adjust the handle bar height on a mongoose bicycle?

Answer by  thelostone (1457)

There is a bolt on the top of the bar going into the neck of the handle bar that you will loosen. Once it is loosened the handle bars will raise and lower. Then tighten the bolt once its at the desired height.

Answer by  Brita (15)

There should be a fairly large nut at the base of the neck of the bike. The neck should be just above the frame of the bike. If you loosen that up you can pull the neck and handlebars up or move them down. Then just simply re-tighten the nut.

Answer by  steve9027 (66)

there should be a fairly large nut at the base of the neck. It should be just above your frame. If you loosen that up you can pull the neck and handlebars up or move them down. Then re-tighten the nut.

Answer by  Liz59 (10966)

Well, just keep turning and twisting the handles until it reaches the desired length. Therefore, you just have to make sure the length is adjusted right.

Answer by  champaign9497 (11977)

On the front of the bike where the handle bars hook on there will be a little nut to lower them you have to loosen the nut and adjust the handle bars to the proper height then be sure you always tighten the nut back up.

Answer by  TheProfessor (26)

This will depend on how old you bicycle is. Older bikes will have a "quill" stem that has a bolt on top of the stem to loosen it. Newer bikes have threadless steer tubes and the stem clamps onto the outside of the steerer tube.

Answer by  hunterboy1233 (1)

i took my steering wheel off my bike n put it bak on n it wnt move the tire anymore