How do I replace my Dodge Ram charger crankshaft sensor?

Answer by  babyhueyk (96)

You will find the sensor near the crankshaft pulley- remove the old sensor. Clean the area and bolt the new sensor on. It has been my experience that if it is not clean you will not get a true reading as the sensor is very sensitive. There should not be any adjustment.

Answer by  ben43 (121)

your probably going to have to pull the motor. because the timing cover has to come off the get at the end of the crank. or if its a electronic one pull it off the side of the motor and bolt the new one on.

Answer by  palmerino (637)

On the side of the engine, there will be a sensor bolted near the cranshaft pully. You simply unplug the sensor, unbolt it and replace in reverse order. However, I recommend buying a repair manual from any auto parts store for about $20. It will be very helpful for odd repair jobs on the vehicle.

Answer by  shalana (137)

Is located on the engine behind the hamonic balance and you just need to unscrew it and unplug the wires from the socket in order to remove it then just replace the new one.

Answer by  Jalaine11 (2043)

Go to the local auto parts store where you plan to purchase your new crankshaft sensor. They should be able to help guide you on how to replace the sensor.

Answer by  japratt (1687)

In order to replace the crank shaft sensor on this vehicle you will need to take apart the dash area to locate the sensor.