How do I hook up to amps?

Answer by  anime018 (234)

To connect a amp you must need a RCA wire it is the red , white and yellow wires that come in most amps. If you amp uses speaker wire you can just put the wire in the amp hole and twist the knob till its tight around the wire.

Answer by  booboobear (139)

That depends on what you need to hook up. If you are talking about hooking up a guitar, you first need to find the output jack on your guitar. Then plug the cord (usually a 1/4 inch cable) into one of the input jacks on the amp.

Answer by  bikermicefrmars (100)

An RCA wire which is red, white and yellow that comes in amps are needed to connect it. If speaker wire is used, then just put it in the amp hole.

Answer by  kenny39 (232)

two hook up to amps you will need to buy whats called a "distribution block" once you have this run a single 8-10 gauge power or "hot" wire from the your car battery to the DS block then run seperate hot wires from the other end to each amp

Answer by  hollandevans (20)

An amplifier is used between a non amplified sound source and speakers. The type of connectors required will vary from model to model, so make sure that you have all the proper cables. The amount of power a speaker can handle will also vary, make sure that they match up.

Answer by  thiefraccoon (266)

how to hook up normal audio out to amps? you can buy an adaptor, that goes into your amp's audio in.