How do I go about resetting the security system on a Nissan Quest?

Answer by  timbucktoo (350)

You either need to reset the fuse for the security system, or you need to disconnect the positive battery terminal, turn the car on, then reattach the terminal.

Answer by  ijlalnoor (2656)

I think we can reset the Nissan Quest by just unplugging the battery from the car. Plug it back in after about a minute and the whole system would be reset.

Answer by  Aultero (80)

Turn a key just before on position and press special button located under the dash area and hold them up to 8 seconds.

Answer by  Amber40 (24961)

Usually the only way to reset it is with a Nissan diagnostic tool. So have you dealer looks at it and the should be able to reset it.

Answer by  kalai24 (14)

This vehicle is set in hazard indicator and horn mode when you first receive the vehicle. In hazard indicator and horn mode, when the LOCK button is pushed, the hazard indicator flashes twice and the horn chirps once. When the UNLOCK button is pushed, the hazard indicator flashes once. If hazard indicator and horn mode is not necessary.

Answer by  les59 (852)

To my knowledge, the best way to reset the security system on a Nissan Quest is to unplug the battery cables from the battery of the car, wait about 30 seconds, then reconnect the battery cables to the battery of the car. This resets the whole car.

Answer by  senthil34 (169)

In tests for rollover, it received a 4-Star rating, and in all front- and side-impact crash tests, it received 5-Star ratings Traction control,Front and rear anti-roll bars Four wheel anti-lock brakes,Driver/passenger front-impact airbags 1st/2nd/3rd row overhead airbags,Occupancy sensors Side impact bars,Security system