car repairs






 

Question by  ccno (12)

How do you replace an 02 sensor in a Land Rover?

I need to replace a land rover o2 sensor.

 
+6

Answer by  Atomicrayon (2504)

You'll need to stop by your local automotive store and get a 02 sensor that matches the same brand and type as your Land Rover. Locate the sensor, it'll have a couple rubber guards that can be twisted off by hand. Using a level line up the new one and-swap.

 
+6

Answer by  Amber40 (24961)

It is pretty straightforward. Just locate the old one and unplug it. Then using a special o2 sensor socket, remove it form the exhaust. Install the new one with a bit of o2 sensor friendly anti-seize. Then just plug the o2 sensor back up.

 
+5

Answer by  AnneM (16)

Locate the sensor and with the appropriate tool,remove the sensor and wires. After purchasing a new sensor from your Land Rover dealer, locate the old sensor location. Carefully, with the appropriate tool, place sensor and wires in same position and resecure new sensor in place. Then you can rehook wires. Job is done.

 
+4

Answer by  Amber40 (24961)

First locate the o2 sensor and remove the wire connector. Then remove the actual sensor with a o2 socket. Penetrating oil may need to be needed. Then reverse the process.

 
+4

Answer by  hurricore (66)

Most often the O2 sensor is located on the exhaust manifold with a single wire attached to it. Pull off the wire and unthread the sensor. It can look a little like a spark plug. Thread the new O2 sensor in place of the old one. I suggest High temp loc-tite it will make it easier to remove later.

 
+3

Answer by  laura27 (1216)

Go to auto part store, purchase the same exact 02 sensor for land rover. locate sensor, get 2 rubber guards that twist off by hand. level line on new one.

 
+3

Answer by  Amber40 (24961)

Soak the sensor with penetrating oil. Then unplug the connector and by using a O2 sensor socket, break the sensor free. Then install the new one.

 
You have 50 words left!