How do I remove a Jeep anti-theft system?

Answer by  JohnHolmes (2660)

The system will be difficult to remove if it is on a later model vehicle because the on board computer will not allow flow to the engine if it detects it has been tampered with. You will need to see a Jeep dealer to have it removed.

Answer by  thattractorguy (2970)

Removing the system will probably be next to impossible. You could just remove the fuse that controls the system. If another accessory is controlled by that same fuse, you can rewire the accessory to a different fuse.

Answer by  harshielha (144)

Removing a Jeep anti-theft system is a hectic process for which one has to remove the fuse that controls the system and rewire it with different fuse.

Answer by  JD17 (424)

Under the drivers is a black box. With the battery unplugged, Unplug and remove the black box. Plug battery back in. Also remove relay under the hood.

Answer by  Nithi5233 (4)

To remove the anti theft system of the jeep is by following these steps. 1.find the anti theft alarm in the jeep. 2.now note the anti theft alarm where it is connected 3.now remove or cut the wire and anti theft system also. 4.it is also neccessry to check weather that wire disconnects some other...

Answer by  Atil (130)

In order to remove a Jeep anti-theft system, you first have to locate all the individual components of the system by using the original instructions and the diagrams that came with it. You then have to remove each of the components by using a screwdriver.

Answer by  MattDoofus (31)

This isn't a job for a person with no knowledge about removing an anti-theft system unless you have a manual for your Jeep. You should take your Jeep to a Jeep dealership or any other professional.