electronics






 

Question by  Skrpune (37)

How do I install a Dual Voice Coil from Kicker?

 
+7

Answer by  SallyJ (1010)

The correct wiring depends partly on what resistance you have--2 ohms or 4 ohms--and how many speakers you are installing. B efore hooking up the speakers you need to check the minimum impedance the amplifier in your car will handle. You can get this information from your car's owner manual.

 
+6

Answer by  Amber40 (24961)

Well I assume they would install the same way that any other speaker would. Just connect the + wire to the + terminal and the - wire to the - terminal. Then screw the speaker in place.

 
+6

Answer by  worker5825 (96)

The most common way of installing a DVC woofer is to have one channel drive each voice coil. If you have a 2 channel amp, wire one to each. If you have a mono amp, you will have to check what kind of resistance, or ohm, would fit your situation.

 
+5

Answer by  Jenny25 (939)

You can install the dual voice coil by clicking the edit button. Then under the edit button you will see a list of options that will say install. Then you click the install button and a list of panels will come. Click on dual voice coil. Then follow the instructions for installation.

 
+5

Answer by  lumba (16)

if you're taulcking about the speaker both the right and left outputs from amp are connected to the same speaker. do not connect right and left together there should be seperate terminals for each.

 
You have 50 words left!