Can you tell me how to wire in a remote start for a GM S-10?

Answer by  JohnHolmes (2660)

You will need to wire in the electrical connector right from the battery to the starter which will usually be near the underside rear of the engine. Make sure when you do so that the negative battery cable is disconnected to avoid the risk of possible electrical shock from the unit.

Answer by  TravisUSMC (979)

This can be very tricky. I have installed about 20 of them. Follow the directions closely that come with it and TAKE YOUR TIME. Go slow and easy making sure each wire is exactly where it should be and that all wires are completely insulated with electrical tape.

Answer by  Jdog37 (592)

There is no good way to go about wiring in a remote start on any car. You will be better off leaving it to the professionals that do it all the time and are trained. It is very easy to do it wrong and mess up your wiring harness. Save youself the misery and leave to the professionals.