What is a "mini mac" carburetor adjustment?

Answer by  Madhu (20)

Do the same with low side but back out one and a half. Adjust with low side till it cranks. Once its starts, hold saw wide open and turn high side Counter clockwise till the saw alternates between a high and low vibrato.

Answer by  ijlalnoor (2656)

These are actually two screws, which set the air and the fuel intake. You will have to set it to the right place otherwise take it any local workshop and get it fixed.

Answer by  6ixk (1156)

A mini machined carburetor. They are usually found on older vehicles, and are pretty outdated for todays market. If your looking to get one redone you can check local machine shops. But it is a very rare part, so coming across one will be somewhat of a gold mine. Good luck.

Answer by  kennethjgoodson (4903)

A mini mac carburetor adjustment means you are tightening the screws about 1 and 1/4 to 1 and 1/2 to get the optimal power out of the carburetor. The engine needs to be warm before you do this or it will not work properly and it could stall the motor out after you start it.

Answer by  georgekutty (173)

In "mini mac" carburetor adjestment is two mechanical screws adjustment. one for air and other for fuel. fuel adjustment may higher the vachele raising it unscrew the sound is normal and also air screw adjust properly. Both scerews were adjust properly made best resuult and get very good perfomance. The carburetor adjustment is called tunning.