car repairs






 

Question by  Jeannie28 (33)

On a Buick LeSabre, how do I replace an ignition module?

 
+6

Answer by  dee73 (1062)

you need to look under the hood and locate the module located near the main ignition. Remove tha bolts holding the module on and remove the wires also.Once that is done you are ready to place the new one on. Make sure you have hooked up the wires and replace the bolts tighten them down.

Reply by leeray488 (0):
Since I started with my online business I earn $62 every 15 minutes. It sounds unbelievable but you wont forgive yourself if you don't check it out. >>> bit.ly/SoY0Kn  add a comment
 
+5

Answer by  Jenny30 (161)

Locate the ignition module on your particular year Buick LeSabre. Remove bolts holding module in place. Disconnect wiring harness from module. Reinstall in reverse order.

 
+3

Answer by  cgrid76hotmailcom (545)

First off find the bad one to take off.Then get the new one ready to put back on .Make sure you unhook the battery so you dont cause any fires

 
+2

Answer by  japratt (1687)

To replace the ignition module on your Buick you will need to first get under the hood. Once under the hood you can locate the module near the main ignition.

 
You have 50 words left!