How do you remove/install the ambient temperature sensor from the front grill?

Answer by  Amber40 (24961)

First locate it. It should be on the right side of the headlamp mounting module grille opening. It should have a single screw holding it on. Then simply unhook the connector and reverse the process with the new sensor.

Answer by  thattractorguy (2970)

Remove the front grill to gain access to the sensor. It's in the upper left side when looking at the vehicle head on. Just unbolt it and disconnect the wire.

Answer by  mb (5482)

You will have to remove the front grill to get at the sensor, then the sensor just pulls right out and you pop the new one in.

Answer by  abdulfathah (79)

First locate it. It should be on the right side of the headlamp mounting module grille opening. It should have a single screw holding it on. Then simply unhook the connector and reverse the process with the new sensor. This is the procedure to install the ambient temperature sensor from the front grill of Jeep Grand Cherokee.

Answer by  worker4192 (12)

Disconnect the battery negative cable , the wire harness connector and the ambient temperature sensor. Install the one screw. Reconnect the wire harness connector and the battery negative cable.

Answer by  japratt (1687)

If you are wanting to either remove or install this type of sensor on your grille you will need to first take off the grille. Once the grille is off you can input the wiring that you will need. Once the wiring has been set you can put the griller back on.