How do I remove a drivers seat from a Chevy S-10 pickup?

Answer by  Jennfier (339)

You will need to unscrew the bolts that are holding down the seat down to the floor board. When you unscrew the bolts, you will be able to remove the seat. You can then install the new seat by connecting the same bolts together and screwing the bolts back in making sure it is a tight fit.

Answer by  Amber40 (24961)

All you need to do is simply remove a series of bolt holding down the seat frame. If you have power seats there will be a connector to disconnect also.

Answer by  LoganBFishburn (124)

There are four nuts, one on each corner of the seat where it meets the floor of the truck just take each nut off and pull up on the seat. You may have to push on it a little to break it loose.

Answer by  foxstang (133)

Remove the 4 bolts holding the seat in the vehicle. Unplug any electrical connections from the seat. Unbolt the seatbelt guide from the seatback. Remove the seat from the vehicle.

Answer by  kennethjgoodson (4903)

You are going to need to make sure the seat is all the way forward and you will see 4 bolts holding it down and you are going to need to take the bolts out and then the seat will come right out.

Answer by  kennethjgoodson (4903)

You can look under the seat and you will notice that there are 4 bolts holding the seat down. Take the bolts out and the seat will come right out of the pickup.

Answer by  worker8388 (994)

Slide the drivers seat forward. Using ratchet remove the four bolts that surround the perimeter of the seat. Pull the seat of the vehicle using your arms.

Answer by  Amber40 (24961)

Well if you just have manual seats the just unbolt the four bolts holding the seat in. If you have power seat then just unhook the electrical connect before removing.

Answer by  brownie17 (170)

You will need to take a loose the the bolts that is holding the the seat to the floor board.When you take the bolts a loose remove the seat.