How do I adjust the camber bolt on my car?

Answer by  Amber40 (24961)

You really should be messing with the camber bolt yourself. If you change it you could make the car dangerous to drive. Take it to a good alignment shop and they should be able to dial in the amount of camber you want.

Answer by  Amber40 (24961)

To adjust it, turn it either left or right. The adjustments needs to be the same for both sides. So use a camber tool and don't over do it.

Answer by  Jennytaurus (144)

You must loosen the cam bolt and either pull the tire out or push it in for camber adjustment. If you have a cam bolt in your vehicle, loosen the bolt and turn the bolt until you achieve the camber adjustment that you require. Retighten bolt to make sure the camber bolt doesn't slip.

Answer by  Amber40 (24961)

Since I don't know what kind of car you have it hard to say. Typically you just turn it one way to increase camber and the opposite to decrease camber.

Answer by  HEAJG (500)

Turning it to the left or right should do but it can be very dangerous. Might want to consult a manual book for that.

Answer by  Jaggers (1018)

Place a 4 foot carpenter level on the car hood. Turn the camber bolt to attain a 10 degree camber

Answer by  Deepali (68)

Chamber is normally measured by degree and directions. After that we have to put the jack and remove the alignment. After that we can remove the upper bolt. Then we should install the size cam bolt and nut up all. After completing this make the chamber on zero degree. Now it time to install lower bolt. Now tighten up the lower and upper bolt.